whatsapp

whatsApp

Have any Questions? Enquiry here!
☎ +91-9972364704 LOGIN BLOG
× Home Careers Contact
Back
PROPOSED MODEL FOR THE SMART VEHICLE ACCIDENT DETECTION AND SEAT CONTROL SYSTEM USING RACK AND PINION AND SENSOR
PROPOSED MODEL FOR THE SMART  VEHICLE ACCIDENT DETECTION AND SEAT CONTROL SYSTEM USING RACK AND PINION AND SENSOR

ABSTRACT

Accidents on the road have been one of the major causes of unnatural and untimely death all over the world. This is one of the most important issues of concern all over the world. With the increase in road traffic day by day, all over the world, it may be little difficult to avoid such accidents on the road but with the advent of smart technology, there is an possibility to provide save the life of driver and passenger. So in this system an attempt is made to propose a system for a smart car that will detect the accident, and immediately the driver and passenger sheet will move back side for 6 inches and save the life of driver and passenger  through the rack and pinion it has the following features

1 auto sheet movement using rack and pinon

2. auto window open and spray water  when it gets fire inside the vehicle

3.auto window close during rain

4. when it met accident the window and door will open 

staring parts

top 100+ projects ideas

mechanical projects academic

 

1 Fire alarm is fixed in center of the bus

2. SPRINGLER

Each sprinkier is covered 3 ft area

The sprinkler is connected in common  water source pipe which is connected with the ater pump at every 3 ft area

3.sensors

Temperature sensor is used to sense the heat and LDR   (light dependent resistance ) is used to sense the fire) the sensor is connected with the  every springler

 

4.Emergency Door

The emergency door is controlled by hydraulic  system which is controlled by the sensor  (open and close)

5.Dc water pump

Operating voltage      = 12 volt

The DC water submersible pump is fixed with water tank

6.Water tank

capacity          =   5 ltr

7.size of the volvo bus

  Size of the model        =                36’’  X   18’’ x 18’’

8. Plastic Wheel for Movement

  Plastic wheel          =           12 ‘’

9. Material  used 

    MS  for base and frame

   Plastic material for body

10. lead acid battery        = 12 volt  7.5 AHC

 

COST EFFECT

Srl no

Components

Appx rate

01

frame

1500/00

02

12 volt dc motor

 

03

6 ‘’ wheel       4 nos

1200/00

04

 

 

05

 

 

06

 

 

07

Rack and pinion   system        

1500/00

08

 

 

0 9

12 volt    lead acid battery

1000/00

 

 

 

 

 

Material used;-

1. 1 ½ inch l angle MS material

2 Plastic  material for body

 

3. plastic wheel 9 inch

 

https://www.mifratech.com/public/
https://www.mifratech.com/public/
https://www.facebook.com/mifratech.lab
https://twitter.com/mifratech

 

Popular Coures