The article explains a very simple method of acquiring 220V AC from a 12v DC source. The idea utilizes inductor/oscillator based boost topology with the help of the IC 555.
We are quite familiar about inverters which convert a DC potential to higher AC potentials at mains levels.
However these units involve complex and expensive configurations for acquiring the required outputs.
A much simpler approach of achieving the above results is by employing a oscillator mosfet boost converter circuit.
If the waveforms are not critical for your applications this method can be a lot simpler and cheaper to implement.
As we all know inductors always try to oppose instant changes in current polarity through it, therefore during the negative pulses when the mosfet remains switched OFF, forces the coil to dump the stored potential in it in the form of high voltage EMF pulse into the output.
This voltage may be equal to 220V and gives rise to the required potential at the shown outlet of the circuit.
The above straightforward operation is repeated continuously at the given frequency providing a sustained 220VAC at the output.
The BC547 and its base network is introduced for limiting the output voltage to the required degree.
For example if the required output is 220V, the 47K preset may be adjusted such that the220V mark never exceeds, irrespective of the coil back emf rate or the input voltage fluctuations.
The mosfet can be any 30V, 50 amp type, for example a NTD4302 may be used.
The coil wire should be thick enough to hold up to 30 or more amps.